DIY – How to Make Sweater Sprinkles with Polymer Clay

DIY – How to Make Sweater ‘Sprinkles’ with Polymer Clay. The other week, the theme on the blog was sprinkles. I planned to make a different DIY with these supplies earlier, but it didn’t quite pan out how I thought, so I still had them rolling around on my desk.

So for this week, I hope you don’t mind, but we’re reverting back to the Sprinkles theme for this really easy DIY.

You will need:

Polymer Clay in ‘Sprinkles’ colours.

Pin Badge / Tie Tacks with Clutch.

Glue. Strong glue for polymer clay.

How to:

Roll your polymer clay into 1cm (or just under half inch) balls and bake according to instructions.

Then …

Of course these (being pins) are better off poked through sweaters with an open weave (like this waffle knit) so they don’t leaves holes. Remember to remove them before washing too! Yes, slightly silly, but I like the colours and I think they’re fun (and thanks because they’re not driving me nuts any more escaping on the floor!)